Jeep 42RLE Deep Transmission Pan, Heavy Duty, Extra Capacity Cast Aluminum

Jeep 42RLE Deep Transmission Pan, Heavy Duty, Extra Capacity Cast Aluminum
Jeep 42RLE Deep Transmission Pan, Heavy Duty, Extra Capacity Cast Aluminum

Jeep 42RLE Deep Transmission Pan, Heavy Duty, Extra Capacity Cast Aluminum
This listing is for a Heavy Duty Deep Transmission Pan with 1 to 1.5 Quarts Extra Capacity(depending on application) for the 42RLE Transmission with a Cast Aluminum finish. PML designed this transmission pan in response to customer demand to replace the stock 42RLE pan. It has a low profile as many vehicles with this transmission have clearance issues with skid plates, exhaust routing, or cross frame members. A magnetic drain plug and all mounting bolts are included with the pan. This pan has been designed for. + Cooling - extra capacity(1-1.5 quarts above stock), fins, and aluminum construction for reported temperature drops of 10 to 35 degrees. + Clearance - medium height maintains clearance.

+ Drain Plug - on the side for safety. + Secure Seal - machined flat gasket flange for a leak free seal. + Strength - high quality aluminum, thick walls. + Fins on bottom of pan for additional clearance. + Designed to work with the stock filter and gasket.

This pan has been installed in the following vehicles. + Jeep Wrangler JK 2007 to 2011 with V6 engine.

These newer Wranglers have the exhaust routed close to the transmission pan. There are three bolts that are difficult to access. We have had customers install this pan on many models. To make access easier, they either loosened the transmission mount and jacked it up or used a pry bar to temporarily move the exhaust out of the way. A customer with a 2008 Jeep Wrangler X was unable to move the exhaust far enough, however. + Jeep Liberty KJ and KK all years with this transmission (some Liberty models have 5-45RFE transmission which has 15 bolts on the pan). + Dodge Ram 1500 2006 to 2012 with 3.7L V6 with the 4 speed transmission. + Chrysler 300 (not 300C) 2005 to 2010 with V6 engine and 4 speed transmission. This pan may also fit the following vehicles. + Dodge Challenger 2008 to 2010 with 4 speed transmission. + Dodge Magnum SE/SXT 2005 to 2008 with 4 speed transmission. + Mitsubishi Raider 2007 to; 2008 with 3.7L V6. Configurations vary so always check your vehicle. This transmission has 13 bolts holding the pan onto the valve body. The 42RE transmission, which also is found on Jeep and Dodge trucks/SUVs, has 14 bolts and is Deep Pan part# 9862. The Dodge 5-45RFE transmission is found on Ram 1500, Liberty and Wrangler with diesel engines and that pan has 15 bolts and is Deep Pan part# 10304. Verify which transmission you have and look for ground clearance and interference from frame cross members or exhaust components. Pan dimensions can be found below in our Technical Information section. Some 2005 and 2006 Rubicons have reported the frame or skid plate support is close to or contacts the drain plug on the PML pan. This required some modifications to frame or support. T his pan is designed to work with the stock filter. The interior of the pan has a filter support. Use a stock filter with this pan. No filter extension is needed. WE ARE NOT RESPONSIBLE FOR YOU ORDERING A PART THAT DOES NOT FIT YOUR VEHICLE. Please see the Technical Information/Identification Guide below for information on how to properly assure pan fitment. We have an ASE certified transmission tech, with 25+ years experience rebuilding transmissions, available to answer your questions. You COULD pay LESS, or you could do it RIGHT the FIRST time and make it your LAST TIME. The above photo shows the interior of the 42RLE Deep Pan.

Some vehicles use a special dipstick that hits the bottom of the pan to check the transmission fluid. The ledge for the dipstick is the half circle on the left side of the image. This ledge is at the same location as the bottom of the stock pan.

In the above photo you can see this pan has a boss on the front side of the pan near the drain hole that can be machined for a temperature sending unit. The drain hole is on the passenger side of the front and the boss is on the driver's side of the front. The boss on the bottom of the pan is an alternative drain hole location. On some Jeep Rubicons (probably 2003 to 2006 models), the drain is close to the cross member or support bar so check clearance carefully and note that draining fluid will require some care. A boss on the same side as the drain is for optional temperature sending units, this can be drilled and tapped to accommodate from 1/8 to 1/2 NPT.

Above you can see a side-by-side comparison of the Deep Pan with the stock pan. In the above photo you can see the difference in depth of the Deep Pan vs Stock. The above diagram shows the dimensions in inches of the Deep Pan so you can check clearances under you vehicle before ordering.

Our products have proven to be trouble free since we began making them in 2000. If the pan or cover you receive is determined to have some kind of manufacturing defect i. Machining problem, leak due to porosity in pan wall, PML will replace the part. If you run a cover or pan into a boulder and it cracks or is damaged, well, there's nothing PML can help you with there. Our products are designed to fit factory original equipment. However, in some applications, or because of the use of certain factory options and/or after market equipment, there may be clearance or fitment problems between our products and your vehicle components.

PML provides dimensions and pictures so you can check your vehicle before ordering. It is the responsibility of the vehicle owner and installer to install the part correctly and to ensure that there is no contact between the PML part and other moving or fixed vehicle components. World Wide Specialty Parts and PML assumes no liability, expressed or implied, for damage or injury to persons or property.

For options and additional costs No exceptions. You can see how much it will cost additionally by. Selecting see details on each Item. Please note our valve bodies have identifying markers and tags on them, if you try and return another manufacturers valve body the return will be denied.

This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts & Accessories\Transmission & Drivetrain\Automatic Transmission Parts". The seller is "worldwidespecialtypartsvbx" and is located in this country: US. This item can be shipped to United States, Canada, United Kingdom, Denmark, Romania, Slovakia, Bulgaria, Czech Republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Australia, Greece, Portugal, Cyprus, Slovenia, Japan, China, Sweden, Korea, South, Indonesia, Taiwan, South Africa, Thailand, Belgium, France, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Germany, Austria, Bahamas, Israel, Mexico, New Zealand, Philippines, Singapore, Switzerland, Norway, Saudi Arabia, United Arab Emirates, Qatar, Kuwait, Bahrain, Croatia, Republic of, Malaysia, Brazil, Chile, Colombia, Costa Rica, Panama, Trinidad and Tobago, Guatemala, Honduras, Jamaica, Antigua and Barbuda, Aruba, Belize, Dominica, Grenada, Saint Kitts-Nevis, Saint Lucia, Montserrat, Turks and Caicos Islands, Barbados, Bangladesh, Bermuda, Brunei Darussalam, Bolivia, Ecuador, Egypt, French Guiana, Guernsey, Gibraltar, Guadeloupe, Iceland, Jersey, Jordan, Cambodia, Cayman Islands, Liechtenstein, Sri Lanka, Luxembourg, Monaco, Macau, Martinique, Maldives, Nicaragua, Oman, Peru, Pakistan, Paraguay, Reunion, Vietnam, Uruguay.


Jeep 42RLE Deep Transmission Pan, Heavy Duty, Extra Capacity Cast Aluminum


Home    Archives    Contact Form    Privacy Policy Agreement    Terms of service